McElroy Discussion Forums

2-6 Pitbull
Page 1 of 1

Author:  plore0523 [ September 9th, 2010, 10:59 pm ]
Post subject:  2-6 Pitbull

Just got the new 2-6 Pitbull today. What a great machine.

Author:  Joshua [ September 10th, 2010, 8:41 am ]
Post subject:  Re: 2-6 Pitbull

We are glad you like it! I have been pretty impressed with the machine thus far. It is so much easier than a No. 28 for 6 inch in ditch fusions. I hope others share your sentiments!

Author:  dkolasa [ February 7th, 2012, 6:11 pm ]
Post subject:  Re: 2-6 Pitbull

The PB26 has been well received here too. Do you or anyone else have the tables that convert the FORCE (lbs) to the torque wrench reading (foot pounds) for this unit?

Author:  tulsamurph [ February 8th, 2012, 9:32 am ]
Post subject:  Re: 2-6 Pitbull

Check out page 6-1 in the No. 26 manual. In the lower, right corner there is a table showing the necessary torque to provide a given amount of force.

Our manuals are now easier to get to, thanks to the new website layout. From the Fusion home page, look on the left under Support. The second link is Product Manuals, and it will take you to a page where you can just select your machine and access the manual quickly and easily.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group