McElroy Discussion Forums
http://forums.mcelroy.com/fusion/

mitered pipe
http://forums.mcelroy.com/fusion/viewtopic.php?f=1&t=1334
Page 1 of 1

Author:  GeneralQuestion [ December 1st, 2010, 5:22 pm ]
Post subject:  mitered pipe

Is it possible to actually miter 16" HDPE piping & fuse the mitered ends together, or would you need to use mitered fittings with a squared end?

Thanks
Matt J.

Author:  Joshua [ December 1st, 2010, 5:30 pm ]
Post subject:  Re: mitered pipe

You miter the ends with a saw and use mitered inserts.

Author:  Jason [ June 27th, 2011, 10:31 am ]
Post subject:  Re: mitered pipe

To expand a little bit on what Josh is saying:

The miter inserts are designed to produce a more balanced application of interfacial pressure for the fusion joint. They are also designed to produce a better grip on the pipes being miter fused. It is best to use inserts which are specifically designed for mitered fusion for these reasons.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/