McElroy Discussion Forums

McElroy Fusion Discussion
It is currently November 17th, 2019, 9:32 am

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: MC1236 spacing and stuff
PostPosted: June 4th, 2010, 12:27 pm 
Offline
Contributing Member

Joined: December 8th, 2009, 2:24 pm
Posts: 35
Hi

I just did the next bit of a 24" job for the continuation of a sewer line part which was under a bridge discussed in the a previous thread.

We were in a ditch and had tight space restrictions as the photos show.

What I forgot to check and we had to dig out extra space for, is the space needed for the carriage to move. :oops: This was complicated by the fact the back hoe could not reach any further.

In the ditch we fused a 45 degree bend so the machine was in the configuration needed to do that with the further arm removed and the correct way round.

When we came to do the straight and final fuse, the pipe sticking out the ground ( unmovable ) went into the movable carriage section and we were not about to turn the machine around then.

So dug we did and I jacked up the pressure to 1000psi to get the carriage to close enough ( the undercarriage pressed itself into the ground of the side of the hole ) as it was getting to the point of running out of time.

It was just enough, lesson learnt, leave enough space and then some.

We tried to leave enough space below to use the jacks on the machine but still needed to extract the machine by hooking up only one side and sliding it around the pipe, removing the pins from the hydraulic rams near the opporator to give us some space and up the slope till we could close the machine and connect the lifting bar. :roll:

Picture of this excluded as Josh would pass out if he saw that. :lol:

Pics


Attachments:
File comment: Now you see it, now you dont
02-06-10_1945.jpg
02-06-10_1945.jpg [ 51.52 KiB | Viewed 7161 times ]
File comment: final fuse, no way around this
02-06-10_1849.jpg
02-06-10_1849.jpg [ 26.29 KiB | Viewed 7182 times ]
File comment: 45 bend with further fixed arm removed
02-06-10_1159.jpg
02-06-10_1159.jpg [ 50.98 KiB | Viewed 7152 times ]
Top
 Profile  
 
PostPosted: June 4th, 2010, 12:48 pm 
Offline
Fusion Expert
User avatar

Joined: December 29th, 2009, 10:12 pm
Posts: 103
Location: Tulsa, Oklahoma
Great pictures, and kudos to you for figuring out a way to get the job done!

Regards,
John


Top
 Profile  
 
PostPosted: June 7th, 2010, 9:58 am 
Yepper, that last fusion can be a doozy. :D

Sometimes you have to do what you have to do. I also try to avoid taking pics of me breaking the rules. :lol:


Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group