McElroy Discussion Forums

McElroy Fusion Discussion
It is currently November 14th, 2019, 4:29 pm

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: October 10th, 2014, 9:52 am 
Offline
New Member

Joined: October 16th, 2007, 2:01 am
Posts: 20
Location: Wisconsin, USA
:?: Re-installing the C-Bored blade holder along with the V-Ring seal below it. I see on the schematic how the seal should be oriented in reference to the facer cover but am wondering if the seal is supposed to be stretched around the blade holder & then somehow the flat lip gets worked around the lip of the facer cover or if the seal just lays in between the driven sprocket & blade holder surrounding the 4 SHCS's?


Top
 Profile  
 
PostPosted: October 10th, 2014, 12:44 pm 
Offline
New Member

Joined: October 16th, 2007, 2:01 am
Posts: 20
Location: Wisconsin, USA
I think I figured it out on my own... Best to remove the facer cover, install C-Bored blade holder into facer cover, flip this assy over & install V-Ring seal onto blade holder (Angle side towards blade hldr/facer cover according to schematic) & then install facer cover/blade hldr/seal assy onto facer. :lol:


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group