|McElroy Discussion Forums
|26 Facer V-Ring Seal Install
|Page 1 of 1|
|Author:||jgeschke [ October 10th, 2014, 9:52 am ]|
|Post subject:||26 Facer V-Ring Seal Install|
Re-installing the C-Bored blade holder along with the V-Ring seal below it. I see on the schematic how the seal should be oriented in reference to the facer cover but am wondering if the seal is supposed to be stretched around the blade holder & then somehow the flat lip gets worked around the lip of the facer cover or if the seal just lays in between the driven sprocket & blade holder surrounding the 4 SHCS's?
|Author:||jgeschke [ October 10th, 2014, 12:44 pm ]|
|Post subject:||Re: 26 Facer V-Ring Seal Install|
I think I figured it out on my own... Best to remove the facer cover, install C-Bored blade holder into facer cover, flip this assy over & install V-Ring seal onto blade holder (Angle side towards blade hldr/facer cover according to schematic) & then install facer cover/blade hldr/seal assy onto facer.
|Page 1 of 1||All times are UTC - 6 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group