McElroy Discussion Forums

McElroy Fusion Discussion
It is currently November 20th, 2019, 7:21 pm

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: February 6th, 2012, 1:31 pm 
Offline
New Member

Joined: February 6th, 2012, 1:15 pm
Posts: 1
I am seeing nowhere, after looking everywhere on line, how to calculate the necessary foot pounds needed to fuse on a manual pitbull using McElroys torque wrench adapter for small pitbulls. I have the correct length torque wrench.
How is one suposed to figure out the ft/lb reading? Do I use, for nexample;
4" IPS pipe, DR 11. Wall thickness of .42", x pie, x 75(InterFacialPressure)?

This gets me approx 100. Is this my foot/pounds reading? It seems like an awfull lot of force when I try it...

Please don't answer with the bead size, as I would like to know how to do this calculation.


Top
 Profile  
 
PostPosted: February 6th, 2012, 5:28 pm 
Page 6-1 of the product manual discusses this. The manual can be found at http://static.mcelroy.com/parts_finder/documents/2557.pdf?-981314793.

Here is the page in .jpg format.


Attachments:
no 14 calc.jpg
no 14 calc.jpg [ 83.88 KiB | Viewed 4543 times ]
Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group