McElroy Discussion Forums
http://forums.mcelroy.com/fusion/

Facer gear removal
http://forums.mcelroy.com/fusion/viewtopic.php?f=2&t=1445
Page 1 of 1

Author:  GeneralQuestion [ February 7th, 2012, 1:47 pm ]
Post subject:  Facer gear removal

How do you get the drive gear off a facer motor? Part #811901

Author:  AMcMillan [ February 7th, 2012, 3:27 pm ]
Post subject:  Re: Facer gear removal

that # did not show up in parts finder

Author:  tulsamurph [ February 7th, 2012, 4:35 pm ]
Post subject:  Re: Facer gear removal

Try 819901.

As a general rule, when it comes to removing a sprocket from a facer motor, first make sure that there is no locking pin or locking screw through the middle of the shaft. If the sprocket is simply threaded onto the motor, as this drawing indicates, a sharp rap with a hammer on a box end wrench turning opposite the direction of motor rotation should break the sprocket free. If you use an air impact wrench, you can spin the facer motor fast enough to destroy the windings, so I don't recommend that. If it doesn't budge, stop and evaluate to make sure something has not been overlooked. The gear might be rusted or stuck on, but it will usually break loose with one or two sharp raps.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/