McElroy Discussion Forums

McElroy Fusion Discussion
It is currently October 20th, 2020, 5:13 pm

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: insert positioning
PostPosted: April 4th, 2012, 5:02 pm 
Offline
Senior Member

Joined: September 29th, 2009, 2:45 pm
Posts: 239
There seems to be some confusion on positioning the inserts as it relates to the "beveled" end. Which side should the bevels face, and is it important in general positioning and why?


Top
 Profile  
 
 Post subject: Re: insert positioning
PostPosted: April 5th, 2012, 5:01 pm 
Offline
New Member

Joined: October 14th, 2009, 1:31 pm
Posts: 10
put them in so the bevel is facing away from the facer..the bevel is for extra clearance when using molded fittings so you slip them thru a little farther to help with face off if needed


Top
 Profile  
 
 Post subject: Re: insert positioning
PostPosted: April 5th, 2012, 6:11 pm 
Offline
Fusion Expert
User avatar

Joined: December 29th, 2009, 10:12 pm
Posts: 103
Location: Tulsa, Oklahoma
Please let us know which inserts you are using to better answer your question.

Thank you!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group