McElroy Discussion Forums
http://forums.mcelroy.com/fusion/

insert positioning
http://forums.mcelroy.com/fusion/viewtopic.php?f=2&t=1462
Page 1 of 1

Author:  GeneralQuestion [ April 4th, 2012, 5:02 pm ]
Post subject:  insert positioning

There seems to be some confusion on positioning the inserts as it relates to the "beveled" end. Which side should the bevels face, and is it important in general positioning and why?

Author:  mikee [ April 5th, 2012, 5:01 pm ]
Post subject:  Re: insert positioning

put them in so the bevel is facing away from the facer..the bevel is for extra clearance when using molded fittings so you slip them thru a little farther to help with face off if needed

Author:  tulsamurph [ April 5th, 2012, 6:11 pm ]
Post subject:  Re: insert positioning

Please let us know which inserts you are using to better answer your question.

Thank you!

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/