McElroy Discussion Forums

McElroy Fusion Discussion
It is currently November 14th, 2019, 3:20 am

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: August 22nd, 2012, 10:03 am 
Offline
Contributing Member

Joined: December 8th, 2009, 2:24 pm
Posts: 35
Hi Guys

We got our new DynaMc hand pump - Serial : C51355.

We tried it out twice and found it took a minimum of 15 seconds to pump the jaws open, remove the heater and close it then still add time pump it up untill fusion pressure, is this still in the maximum time for a fusion.

Took about 20 pumps and each pump moves the carriage about 1/4 inch per stroke of the pump.

Is it possible to adapt the hand pump machine to the electic pump HPU? eg serial 1272701.

Thanks
Phil


Top
 Profile  
 
PostPosted: September 11th, 2012, 8:36 am 
Sorry for the delay, here is the answer that I received:


We can convert a DynaMc HP to an EP. First, take off all the hydraulic components such as the hand pump, directional valve, hoses, and fittings from the hand pump machine and then add the fittings, and hoses from a DynaMc EP 2 Jaw Carriage Hydraulic/Plumbing Schematic 1274701. Add the DynaMc EP HPU and you now have an EP unit.


Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group