McElroy Discussion Forums

DynaMc Hand Pump time question
Page 1 of 1

Author:  PhilSask [ August 22nd, 2012, 10:03 am ]
Post subject:  DynaMc Hand Pump time question

Hi Guys

We got our new DynaMc hand pump - Serial : C51355.

We tried it out twice and found it took a minimum of 15 seconds to pump the jaws open, remove the heater and close it then still add time pump it up untill fusion pressure, is this still in the maximum time for a fusion.

Took about 20 pumps and each pump moves the carriage about 1/4 inch per stroke of the pump.

Is it possible to adapt the hand pump machine to the electic pump HPU? eg serial 1272701.


Author:  Joshua [ September 11th, 2012, 8:36 am ]
Post subject:  Re: DynaMc Hand Pump time question

Sorry for the delay, here is the answer that I received:

We can convert a DynaMc HP to an EP. First, take off all the hydraulic components such as the hand pump, directional valve, hoses, and fittings from the hand pump machine and then add the fittings, and hoses from a DynaMc EP 2 Jaw Carriage Hydraulic/Plumbing Schematic 1274701. Add the DynaMc EP HPU and you now have an EP unit.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group