 |
Contributing Member |
Joined: December 2nd, 2008, 8:10 pm Posts: 34 Location: Bellevue, WA
|
Hello All,
We have a 30" job this summer that is quite unique. Our customer will be slipplining two 36" wood stave pipes with 30" for a total run of approx. 1600' each. Given the existing pipe's placement and angle they are going to have to weld on an incline. We are not sure yet of the grade but I am hoping to give them what our T900 is set up for.
Other than the possible reverse drag that we will have to account for, is there anything on the machine regarding the motor or hydraulic functions that I would have to be concerned with?
Thank you.
Eric
|
|