McElroy Discussion Forums

McElroy Fusion Discussion
It is currently June 15th, 2019, 10:19 pm

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: April 9th, 2013, 9:33 am 
Tracstar Pendant Setup
To turn pendant on turn key to right
To turn pendant off turn key to off

Navigate using numeric keys, <+ >and < - > keys, < = > key, < C > key
Password as shipped from McElroy 123
Setup fusion parameters
When starting a job the screen should read time in upper left hand corner and 1 Setup, 2 Pressure, 3 Menu, on left side of screen and Face, Soak, Fuse with pressure in center of screen.
Follow Instructions on each screen for navigation instructions
Select Setup press 1 on keyboard
CO92 Parameters screen
Press + use parameters on screen
Press - enter new parameters
IF - SELECTED THEN SCREEN BELOW WILL APPEAR
D112 Select pipe material
List of pipe manufactures is programmed into Coach, Scroll thru list using + or – key, make selection and press = key
S030 Heater Temperature
Use Pipe Manufactures recommend temperature, type in temp and press =
Heater off-set 500 = 10, 900 = 60
D140 Piston Area
Press = to default to 500 = 6.010 or 900 = 15.32
S014 Pipe Size
Select IPS, DIPS, OD, mmOD using + or – to scroll up or down
Type in pipe size press =
S018 Pipe Wall Thickness
Select DR,WT, mmWT using + or – key to scroll
Type in parameter selected , press =
D122 Heat (IFP)
Press - to skip or type in IFP if required and press = D124 Soak (IFP)
Type in 0, then press = , or enter IFP if required D126 Fuse (IFP)
Type in pipe manufactures recommended pressure usually 75 and press = D128 Cool (IFP)
Type in pipe manufactures recommend pressure and press = (if different than Fuse IFP), or – to skip
C092 Parameter Screen
Let you review parameters entered press + if ok or – to change
S010 Drag Pressure
Press + to default to 70 (machine drag) or shift carriage selector valve to close and raise pressure,
Using facer pressure valve until carriage starts to move slowly, shift carriage to neutral , let pressure stabilize press + and then = to set drag pressure
NOTE: Drag automatically added to Soak and Fuse pressure


Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group