Tracstar Pendant Setup To turn pendant on turn key to right To turn pendant off turn key to off
Navigate using numeric keys, <+ >and < - > keys, < = > key, < C > key Password as shipped from McElroy 123 Setup fusion parameters When starting a job the screen should read time in upper left hand corner and 1 Setup, 2 Pressure, 3 Menu, on left side of screen and Face, Soak, Fuse with pressure in center of screen. Follow Instructions on each screen for navigation instructions Select Setup press 1 on keyboard CO92 Parameters screen Press + use parameters on screen Press - enter new parameters IF - SELECTED THEN SCREEN BELOW WILL APPEAR D112 Select pipe material List of pipe manufactures is programmed into Coach, Scroll thru list using + or – key, make selection and press = key S030 Heater Temperature Use Pipe Manufactures recommend temperature, type in temp and press = Heater off-set 500 = 10, 900 = 60 D140 Piston Area Press = to default to 500 = 6.010 or 900 = 15.32 S014 Pipe Size Select IPS, DIPS, OD, mmOD using + or – to scroll up or down Type in pipe size press = S018 Pipe Wall Thickness Select DR,WT, mmWT using + or – key to scroll Type in parameter selected , press = D122 Heat (IFP) Press - to skip or type in IFP if required and press = D124 Soak (IFP) Type in 0, then press = , or enter IFP if required D126 Fuse (IFP) Type in pipe manufactures recommended pressure usually 75 and press = D128 Cool (IFP) Type in pipe manufactures recommend pressure and press = (if different than Fuse IFP), or – to skip C092 Parameter Screen Let you review parameters entered press + if ok or – to change S010 Drag Pressure Press + to default to 70 (machine drag) or shift carriage selector valve to close and raise pressure, Using facer pressure valve until carriage starts to move slowly, shift carriage to neutral , let pressure stabilize press + and then = to set drag pressure NOTE: Drag automatically added to Soak and Fuse pressure
|