McElroy Discussion Forums

McElroy Fusion Discussion
It is currently June 19th, 2019, 6:32 pm

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: April 11th, 2013, 10:36 am 
Offline
Senior Member

Joined: September 29th, 2009, 2:45 pm
Posts: 239
having trouble removing the bearimg inside the facer.. any tips?


Top
 Profile  
 
PostPosted: April 11th, 2013, 1:47 pm 
Remove the four machine screws from the blad holder. Once the blade holders come off, Remove the retaining ring (item 21). If you need to tap it from the bottom side, rotate the chain until you can remove the master link. Remove the bottom sprocket (item 24). and then tap using a brass punch. Work the punch around the circumference of the bearing until it pops out.
When installing the new bearing, make sure that you do not get it into a bind.

Per print, there isn't any locking compound used.

Hope this helps!


Attachments:
28 facer.jpg
28 facer.jpg [ 193.24 KiB | Viewed 4310 times ]
Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group