McElroy Discussion Forums
http://forums.mcelroy.com/fusion/

Sidewall Heater Adapter decoder
http://forums.mcelroy.com/fusion/viewtopic.php?f=2&t=1600
Page 1 of 1

Author:  Joshua [ April 19th, 2013, 10:44 am ]
Post subject:  Sidewall Heater Adapter decoder

Here is a P/N decoder for heater adapters. This helps you get an idea of what the part number of the adapter tells you.

Attachments:
Heater adapter code system.png
Heater adapter code system.png [ 116.56 KiB | Viewed 4165 times ]

Author:  Joshua [ October 1st, 2013, 2:10 pm ]
Post subject:  Re: Sidewall Heater Adapter decoder

Recently, I have received questions about the size hole in the middle of the heater adapter. The customer understood that they were high flow and low flow adapters or something similar to this. If you run into a customer with this issue, here is the history on adapters per our engineering group.

Over the years we have designed adapters to fit the fittings that were manufactured at the time. As fitting manufactures designed different fittings we designed adapters to fuse them. Since there has been no real consistency or standardization in the industry as far as fitting dimensions, we have not been able to develop any clear standardization in our adapters. Our coding system does not specify the inner hole diameter on adapters. This is one of the reasons we developed the tables shown in today’s catalogue; so users could select the proper adapter based on the fitting they were using. The best suggestion I can give is know what fitting you are attempting to fuse and pick the proper adapter set from the tables. If your fitting is not shown, contact Engineering and have them design what they need.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/