McElroy Discussion Forums

McElroy Fusion Discussion
It is currently April 25th, 2019, 7:37 am

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: May 31st, 2013, 11:48 am 
I got this tip from an astute technician and thought I would pass it along.

Josh,

We’ve been experiencing problems with the sensing modules on the GFCI setup on our machines especially after washing the machines. Just thought I would pass along a solution I have found. If the sensing module is flashing fault and cannot be reset I have taken the sensing module apart and blown the inside out with compressed air. A tiny amount of moisture collects at the bottom of the sensing module and causes havoc with the circuit board. After drying the module I use RTV gasket maker to seal the joints of the module case and I then remove the yellow decal from the front and smear RTV around the rubber push buttons to make them water tight. I use superglue to reinstall the decal and we’re back up and running. This is working for us so you might pass the word along to others if they’re experiencing this.


Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group