McElroy Discussion Forums
http://forums.mcelroy.com/fusion/

oil viscosity
http://forums.mcelroy.com/fusion/viewtopic.php?f=2&t=1633
Page 1 of 1

Author:  GeneralQuestion [ August 7th, 2013, 6:18 am ]
Post subject:  oil viscosity

Hello guys, I'm wanting to no what the engine oil viscosity should be used On the trackstar 630 and 900 welders all help would be much appreciated as there is nothing written down in the operations manual

Author:  Joshua [ August 19th, 2013, 12:56 pm ]
Post subject:  Re: oil viscosity

Hello,
It will depend on the conditions you are fusing in. At the factory, we use 10w30 CD (diesel rated).



For Hydraulic Oil:
Take a look at this chart:
http://www.mcelroy.com/pdf/Hyd_Fluid.pdf

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/