McElroy Discussion Forums

McElroy Fusion Discussion
It is currently November 14th, 2019, 1:16 am

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: oil viscosity
PostPosted: August 7th, 2013, 6:18 am 
Offline
Senior Member

Joined: September 29th, 2009, 2:45 pm
Posts: 239
Hello guys, I'm wanting to no what the engine oil viscosity should be used On the trackstar 630 and 900 welders all help would be much appreciated as there is nothing written down in the operations manual


Top
 Profile  
 
 Post subject: Re: oil viscosity
PostPosted: August 19th, 2013, 12:56 pm 
Hello,
It will depend on the conditions you are fusing in. At the factory, we use 10w30 CD (diesel rated).



For Hydraulic Oil:
Take a look at this chart:
http://www.mcelroy.com/pdf/Hyd_Fluid.pdf


Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group