McElroy Discussion Forums
http://forums.mcelroy.com/fusion/

DynaMc EP solenoids
http://forums.mcelroy.com/fusion/viewtopic.php?f=2&t=1641
Page 1 of 1

Author:  Joshua [ October 1st, 2013, 10:50 am ]
Post subject:  DynaMc EP solenoids

How to check the solenoids on the DynaMc EP HPU.

Step 1: Ignore the Ohms reading that is marked on the body.

The solenoids have an internal rectifier network, so the ohms reading should be really high. If measured using the diode-checker function, it should be about 1.5 volts.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/