McElroy Discussion Forums

McElroy Fusion Discussion
It is currently December 13th, 2019, 7:54 pm

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: October 31st, 2013, 10:09 am 
Offline
New Member

Joined: October 31st, 2013, 9:43 am
Posts: 1
Our DL4501 has drifted a little low. Reads 1495 psi with a test input of 1500. Does the pressure transducer have an adjusment pot inside to correct this? I hate to take it apart without knowing there is an adjustment I can make. Our transducer is a model 3-0528 that came original on the unit.


Top
 Profile  
 
PostPosted: October 31st, 2013, 3:39 pm 
Hello Nathan,

There is not an adjustment in the transducer. The unit can be calibrated at some of our distributor locations as well as here in Tulsa. It should be calibrated once per calendar year. you can see the date the unit was last calibrated on the joint report. Check line 25. (see image)

Your distributor can get your unit back to us for recalibration if needed.

Please let me know if I can assist.


Attachments:
joint report.jpg
joint report.jpg [ 113.59 KiB | Viewed 4935 times ]
Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group