McElroy Discussion Forums
http://forums.mcelroy.com/fusion/

Hillbilly method of checking flow on 28 fusion machines
http://forums.mcelroy.com/fusion/viewtopic.php?f=2&t=1666
Page 1 of 1

Author:  Joshua [ October 31st, 2013, 3:17 pm ]
Post subject:  Hillbilly method of checking flow on 28 fusion machines

This only works for the newer black facer motors, not the older green ones.

Mark a blade on the facer and then turn it on.
For a T28 the facer should be around 79 RPM.
The Rolling 28 should be around 49.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/