McElroy Discussion Forums

MEB00056 and MEB00055 cylinder rod stud
Page 1 of 1

Author:  Doug Kimblern [ November 1st, 2013, 10:21 am ]
Post subject:  MEB00056 and MEB00055 cylinder rod stud

We have had a few instances of these cylinders getting damaged by impact. Often, the rod end snaps off and the rest of the cylinder is just fine. If this happens, order the rod and the seal kit to repair the cylinder rather than replacing the whole thing. It is a more cost effective solution.

The seal kit is in
The rod is part number MEK00038.

MEB00056.jpg [ 33.04 KiB | Viewed 14673 times ]

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group