McElroy Discussion Forums
http://forums.mcelroy.com/fusion/

How to Update/Calibrate DataLogger 5 Firmware?
http://forums.mcelroy.com/fusion/viewtopic.php?f=2&t=1683
Page 1 of 1

Author:  Fusion_Technologies [ March 27th, 2014, 9:48 am ]
Post subject:  How to Update/Calibrate DataLogger 5 Firmware?

Our DL5 while not connected to a fusion machine is showing 16 psi.

I have downloaded the DL5 Firmware & Calibration Utility. But how do i connect the pressure sender?

The current Firmware on the device is: v5.1 is that the latest version?

Author:  Joshua [ March 31st, 2014, 7:16 pm ]
Post subject:  Re: How to Update/Calibrate DataLogger 5 Firmware?

Order a MKH00146 cable to connect to the transducer and check http://www.mcelroy.com/fusion/support/ for the latest software. It is an easy update.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/