McElroy Discussion Forums

McElroy Fusion Discussion
It is currently December 13th, 2019, 6:51 pm

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: May 17th, 2014, 10:20 am 
Offline
Senior Member

Joined: September 29th, 2009, 2:45 pm
Posts: 239
hello,i am troubleshooting a heater plate for a 28 120vac and am getting resistance of element
at 11.4 ohms instead of recommended value of 8.23 ohms. what is to be done from there on.
the rtd value is ok and the potentiometer is testing ok also.thanks.christian houle.


Top
 Profile  
 
PostPosted: May 23rd, 2014, 11:38 am 
That one is probably borderline. Is the temperature spread an issue? If so, it may not be a bad idea to swap it out. If not, I would leave it alone.

Hope this helps!


Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group