McElroy Discussion Forums
http://forums.mcelroy.com/fusion/

resistance value for 28 heater element 120vac
http://forums.mcelroy.com/fusion/viewtopic.php?f=2&t=1692
Page 1 of 1

Author:  GeneralQuestion [ May 17th, 2014, 10:20 am ]
Post subject:  resistance value for 28 heater element 120vac

hello,i am troubleshooting a heater plate for a 28 120vac and am getting resistance of element
at 11.4 ohms instead of recommended value of 8.23 ohms. what is to be done from there on.
the rtd value is ok and the potentiometer is testing ok also.thanks.christian houle.

Author:  Joshua [ May 23rd, 2014, 11:38 am ]
Post subject:  Re: resistance value for 28 heater element 120vac

That one is probably borderline. Is the temperature spread an issue? If so, it may not be a bad idea to swap it out. If not, I would leave it alone.

Hope this helps!

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/