McElroy Discussion Forums

McElroy Fusion Discussion
It is currently December 11th, 2019, 9:40 pm

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: October 21st, 2017, 1:37 pm 
Offline
Senior Member

Joined: September 29th, 2009, 2:45 pm
Posts: 239
Hi Guys

A pipe stripped the cable of my Pressure Sender Assembly on a datalogger 4, but left the ends of the connectors, can just new connectors replace the old ones or its more complicated than that.

MLE00096 5PIN Eurofast to Feml DB9 Cord

DL14201 Datalogger 4 Digital Pressure Sender Assembly

I find the position of the datalogger and the Pressure Sender Assembly very vulnerable, its only a matter of time before the datalogger and or the Pressure Sender Assembly is hit.

I taking it all off and putting them in the case each time pipe is loader or I move the machine from now on.

Also turning the data ports downwards as an extra precaution.

Thanks


Top
 Profile  
 
PostPosted: October 30th, 2017, 10:49 am 
There is a little more to it than just new connectors. It would be your best option to send it in and have the lab repair it.
Get with your local McElroy distributor to have an RMA issued.
Matt


Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group