McElroy Discussion Forums

McElroy Fusion Discussion
It is currently September 20th, 2020, 2:22 am

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: socket fusion
PostPosted: August 16th, 2006, 4:05 pm 
Offline
Prior Board Member

Joined: August 16th, 2006, 2:05 pm
Posts: 137
I am a geothermal contractor and I use socket fusion in my ground loops. When I fuse 1 1/4 and 2" it takes at least two of us to do this. Is it possible to use the No2CU to do tee, 90 and coupling socket fusion? If not, does anyone know of a tool that will?
Thanks, Dennis D.


Top
 Profile  
 
 Post subject:
PostPosted: August 16th, 2006, 4:05 pm 
Is it possible for you to switch to butt fusion tees and 90 degree ells? This would permit you to fuse with just one person using the No.2LC or No.2CU without modification and create a better fusion joint.
These machines are not suited to socket fusion, but we could discuss a custom machine.


Top
  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group